[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

RE: [ATM] Tooling Up For Carbon Fiber

To: "'Rod Shea'" <RodShea@comcast.net>, <atm@atmlist.net>
Subject: RE: [ATM] Tooling Up For Carbon Fiber
From: "Donald Good" <donald.good@comcast.net>
Date: Thu, 21 Apr 2005 04:30:42 -0700
In-Reply-To: <000e01c5451c$df97de40$6601a8c0@NOTHALDESKTOP>
List-Archive: <http://home.simoivanov.com/pipermail/atm>
List-Help: <mailto:atm-request@atmlist.net?subject=help>
List-Id: The Amateur Telescope Makers List <atm.atmlist.net>
List-Post: <mailto:atm@atmlist.net>
List-Subscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=subscribe>
List-Unsubscribe: <http://www.atmlist.net/mailman/listinfo.cgi/atm>,<mailto:atm-request@atmlist.net?subject=unsubscribe>
Sender: atm-bounces@atmlist.net
thread-index: AcVFHSb29FYxoRASS3CRyUhdjnI+KABP6nbA

-23T(Torr?) is less than 1/2 psi.  This is no where near sufficient for
vacuum bagging.  Are you sure you have the right type of pump?  How high
does the gauge go?

_______________________________________________
ATM mailing list http://www.atmlist.net/

References:
- [ATM] Tooling Up For Carbon Fiber
  - From: "Rod Shea" <RodShea@comcast.net>

Prev by Author: RE: [ATM] Carbon Fiber for Spider Vanes
Next by Author: RE: [ATM] Tooling Up For Carbon Fiber
Prev by thread: RE: [ATM] Tooling Up For Carbon Fiber
Next by thread: RE: [ATM] Tooling Up For Carbon Fiber
Index(es):
- Author
- Thread