[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: ATM At #120, switch to #220?

To: James Lerch <jlerch1@tampabay.rr.com>
Subject: Re: ATM At #120, switch to #220?
From: lowther@att.net
Date: Sat, 07 Apr 2001 07:29:56 -0400
CC: atm@shore.net
References: <000701c0bf12$4a4c3a00$3301a8c0@james>
Reply-To: lowther@att.net
Sender: owner-atm@shore.net


James Lerch wrote:
> 
> Another Bino-Scoper!  :)
> 
> Regarding your question,  I found that at 220 grit I could barely move the
> ROC.  Since you seem to be a distance away from your ROC, perhaps you may
> want to stick with 120 a bit longer.
> 

I found this depends on the hardness of the tool.  If your tool is hard
enough, 220 should change the ROC some.

-- 
Ken Lowther
Youngstown, Ohio
http://www.atmsite.org

References:
- ATM At #120, switch to #220?
  - From: "James Lerch" <jlerch1@tampabay.rr.com>

Prev by Author: ATM Material with negative index of refraction
Next by Author: Re: ATM - Fractional HP Motors for Grinding machines
Prev by thread: ATM At #120, switch to #220?
Next by thread: ATM at the TSP?
Index(es):
- Author
- Thread