Re: [APML] Calibrating STV axes independently

["Jim Janusz" <jjanusz@dc.rr.com>]

OK mystery solved, I think.......

If the problem you are experiencing is a speed error message after the first
calibration run, I believe that it is an initialization error.

If you have been using the ST-V and calibrating normally then do a calibrate
12 followed by 34 everything is fine, as I reported when I said it works for
me.

But, if you attempt to do a calibrate 12 after just turning on the -V it
fails with a speeds error for axis 34 even though you have only done 12.  If
you ignore this error and calibrate 34 it reports a successful calibration.
If you don't trust it you can then redo the 12 calibration and it works
fine.  After this all is well until you restart the -V

Let me know if this solves your problem

Jim

----- Original Message -----
From: "steve banbury" <banburys@sonic.net>
To: <astro-photo@seds.org>
Sent: Monday, June 10, 2002 12:52 PM
Subject: Re: [APML] Calibrating STV axes independently


> At 12:14 PM 6/10/02 -0700, you wrote:
> >Stand by for four copies of this...........
> >
> >I will be out with my ST-V on Tuesday and Wednesday night.  I'll write up
> >everything I do and report back.
> >
> >That should confirm that it works for me as I have not done it for some
> >time.
> >
> >Jim
> >
>
> Thanks Jim--It would be most appreciated!!
> Sounds like Steve W. and I are both missing some key step that will make
it
> all come together.
> I usually can figure these things out, but I get pretty stupid by about 2
AM!
>
> Steve
>
>
> --  APML Archives at <http://astro.umsystem.edu/apml/>  ---
>              Unsubscribe at <majordomo@seds.org>
>


--  APML Archives at <http://astro.umsystem.edu/apml/>  ---
             Unsubscribe at <majordomo@seds.org>