On Thu, 21 Aug 1997 17:40:42 -0400, Mike Regish wrote:
>Yup. I'm sure. I solved the problem. My developer was too old. I ran
out
>of that batch and mixed up a new batch and the problem went away.
I
>noticed, also, with the new developer, that when I put a print from
the
>new batch next to one from the old batch, the borders on the old batch
>prints was green. Been printing since 10:00am and finally got
1 good
>print. At least I know what the problem is. I was going nuts trying
>everything I could think of.
When I started printing color, I had a terrible problem with the
borders coming out blue. Eventually I tracked it down to the tap
water I was mixing the chems with, it had a ph of 8.7...
Peter Drumm
pdrumm@dwave.net <http://www.dwave.net/~pdrumm>
Wausau, Wisconsin
It's been a while since I've done any printing and the bottle of developer
was less than 1/2 full. My photography book suggested a problem with
the developer causing blue streaks and I'm not getting any with this newly
mixed developer, so I'd guess that was my problem...well...as far as the
prints went, anyways. :-)